OAK Module hardware installation
Insert the OAK module to a Raspberry Pi 2 or 3 board like below picture shows
We provide 4 plastic screws, use them to fix the OAK board to Raspberry Pi board such as below shows
The finally looks like below
Until now, the OAK module installation is done, let us move to software installation.
OAK Module software installation
There are two ways to install the OAK module software, one uses our firmware get a quick try, other is you can compile whole things by yourself as the OAK module is open source designed.
Use our firmware
Go to the SwitchPi official website download the switchpi OAK firmware – switchpi-with-gui-1.0.1.imag.zip in here . The switchpi-oak firmware currently version is 1.0.1, built-in Asterisk-13.20 and Dahdi-2.11.1.
Put the downloaded firmware to a Linux distro PC, then following below steps to clone it to an 8G SD card (we strongly suggested to use a class 10 HC SD card such as below SanDisk one), insert micro SD card to your PC with a USB SD card adaptor, the Linux will recognized it like /dev/sda or /dev/sdb which depends on your OS how many drives, you can check it out with command “dmesg”, we are using the /dev/sdb in here.
root@oak:~/pitdm# unzip switchpi-with-gui-1.0.1.img.zip root@oak:~/pitdm# dd if=switchpi-with-gui-1.0.1.img of=/dev/sdb bs=4M
Compile driver by yourself
Please follow the OAK module README.md to compile the driver, https://github.com/lixinswitchpi/oak
Remove the SD card from Linux PC and insert it to your Raspberry Pi 2/3 board, plug the 9V 1A power supply which is with your OAK module together when you received your order as below shows
Please pay attention in here, as our OAK module feeds your Raspberry Pi power as well, thus you DO NOT require to insert the Raspberry Pi USB DC power supply anymore !!!
The default IP address is 192.168.4.99, you can ssh log into it with username “pi”, password “raspberry”.
Now you can use your web browser to log into the GUI of SwitchPi to configure your OAK module, for the details, check it out in here.